Datasouth Documax A3300 Driver
The Datasouth Documax ticket printer can cause potential data loss because the printer has a large print buffer but a very slow print speed. If this printer is to be. AMT Datasouth Documax A - printer - monochrome - dot-matrix overview and full product specs on CNET. : Datasouth Documax A Printer Ribbon: Office Products.
|File Size:||39.9 MB|
|Supported systems:||Windows XP/Vista/7/8/10, MacOS 10/X|
|Price:||Free* (*Free Registration Required)|
Datasouth Documax A3300 Driver
Print a Profile. This will print the current profile only. You must repeat the above steps for each profile, after closing the keypad door.
To clear the printer buffer Datasouth Documax A3300 reset all features in RAM, turn the printer off then turn it back on. To reset all profiles to factory default, perform the following: Reset Printer NVM should be displayed. Press Enter. You will have to Datasouth Documax A3300 any features that you have changed from factory. What can be done to prevent this?
|Delkin CardBus 32 MS||Client Testimonials|
|Ricoh Pentax K-5 Camera||Manufacturer|
When you close the keypad door after you make changes to the current profile the printer will prompt you to press the Profile key to save the current settings as the new default. Press enter at that point to save the current settings as the default for that profile. The settings should remain in memory even if you turn the printer off. If not, then you have a faulty logic board in the printer Datasouth Documax A3300 need to Datasouth Documax A3300 for service. Open the keypad door, press the Next Menu key until M9 is displayed.
AMT Datasouth Documax A3300 Dot-Matrix Printer
Press Enter key. The printer will print the profile.
What does this mean? Please remove the ribbon cartridge and try to power up the printer.
If the printer is on, remove the ribbon cartridge and try to park and load the paper in the printer. If the error persist call tech support for additional information or an Datasouth Documax A3300 number RMA to return printer for repair. We recommend using the IBM Proprinter drivers.
Supplies for DataSouth DocuMax A3300
Set the printer in Menu 3 to: IT will depend on your system and how it handles serial printer communications. The baud rate is set to by default and in Datasouth Documax A3300 applications this is sufficient.
The handshaking is really system dependant. If you have further questions about handshaking or your system requirements then I suggest that you contact your system administrator.
Any recommendation for lubricants? Clean the rails with Denatured Alcohol Only. Datasouth Documax A3300 not use any lubricates. This causes the carriage plate to stall more, until eventually the carriage plate must be changed. Part T 12 I am getting a carriage jam error message on power up.
Stone Systems has been selling terminals and printers since - Product Detail
What could be the problem? This error could be caused by a dirty, blocked or faulty left margin carriage home sensor.
If you move the printhead to the center of the printer and turn on the power, it should attempt Datasouth Documax A3300 home the carriage. If the carriage only moves a slight bit when positioned in the center left to rightand the carriage jam error is displayed, then there is a problem with the sensor.
The sensor is on the left side of the printer, Datasouth Documax A3300 it for dirt or for paper blocking it. Check the logic board connection. If the printhead moves back all the way to the left, stops and shudders before giving the error, then something is blocking the printhead from moving into its home position.
We do not have any NT drivers for this printer. Datasouth Documax A3300 adjusting the detent lever and see if this helps. If you have replaced the Ribbon and moved the detent Closer and still print is light, most likely printhead is worn.